Skip to Main content Skip to Navigation
Journal articles

Testing with SHPB from quasi-static to dynamic strain rates

Abstract : We have developed a new method for separating dispersive waves in elastic and viscoelastic rods from three-point strain and one-point velocity measurements. Stress, strain, displacement and velocity, which were supposed to be homogenous in a rod section, were therefore determined at any point ofthe bar. This method is based on the assumption of a one dimensional and single mode dispersive wave propagation. This method was used in the frequency domain and took into account wave dispersion. It was shown to be stable with respect to noise. The measuring time is increased considerably. Subsequently, the maximum strain which can be measured in a material tested with a classical SHPB (Split Hopkinson Pressure Bar) set-up is also increased and is no more limited by the length of the bars. The method was used to evaluate the rate sensitivity ofaluminum honeycomb over a wide range ofstrain-rates (from 10 -2 to 1000 s -1).
Document type :
Journal articles
Complete list of metadatas

Cited literature [22 references]  Display  Hide  Download
Contributor : Marc Bonnet <>
Submitted on : Thursday, June 27, 2019 - 5:21:17 PM
Last modification on : Thursday, September 24, 2020 - 4:00:24 PM


Files produced by the author(s)



R. Ohtman, M. N. Bussac, P. Collet, G. Gary. Testing with SHPB from quasi-static to dynamic strain rates. Journal de Physique IV Colloque, 2003, 110, pp.397-404. ⟨10.1051/jp4:20020726⟩. ⟨hal-00111384⟩



Record views


Files downloads